|Test Item||Unit||Technical Data|
|Softening Point||℃||＞80( ring and ball method)|
|Extensibility (at 25℃)||cm||＞3|
|Adhesive Strength(at -196℃)||Mpa||＞0.05|
|Flash Point||℃||＞245℃( open cup)|
|Working Temperature||℃||-196 ～60|
It is used as butt joint binder for insulation materials, such as cellular glass, PUF and PIR, preventing insualtion structure from water vapor penetration damaging of insualtion system via butt joints. It supplies a special "buttery" consistency after melt, which facilitates application to insulation surfaces evenly without extra pressure.
Packing and Storage
Packed in woven bags, 25kg/bag;
Store in indoor condition and protect from light.
Application and Cautions
① Apply to clean, dry and oil-free surface only.
②Heat it to 180°C～200°C, apply the melting product on the surface of insulation material with trowel or equipment. Press insulation material on to the pipe/equipment when the adhesive is hot. After cooling down, scratch off the excess adhesive squeezed out from the joint/gap. Apply adhesive smoothly and evenly onto the surface and make sure there is no gap after bonding.<< p="">
③Melt adhesive according to use, strictly control the heating time and temperature. The smoke color can help estimate the temperature: yellow smoke means it is closed to flash poin
④Wear PPE during operation.
Download:FG Cryogenic Adhesive Details